Reliability-
Driven
Engineering
Support
From initial equipment selection to long-term reliability programs — our engineering services maximize asset performance, extend equipment life, and reduce total cost of ownership.
Engineering Support
Across the Asset
Lifecycle
01 — Selection
Equipment Selection & Specification
Engineering-based equipment selection using hydraulic analysis, system curve modeling, and life-cycle cost evaluation to identify the optimal pump, driver, and controls configuration for your application.
- Hydraulic system analysis & modeling
- Pump selection & performance curve review
- Life-cycle cost & energy analysis
- Technical specification writing
- Bid evaluation & vendor comparison
02 — Diagnostics
Diagnostics & Troubleshooting
Rapid diagnosis of pump and system problems — from vibration analysis and performance testing to root cause failure analysis — getting your equipment back to optimal performance quickly and preventing recurrence.
- Vibration analysis & interpretation
- Pump performance field testing
- Root cause failure analysis (RCFA)
- Cavitation & hydraulic problem diagnosis
- Seal failure analysis
03 — Maintenance
Maintenance Services
Comprehensive maintenance programs designed to maximize equipment uptime and extend service life — from preventive maintenance scheduling to full pump overhaul and rebuild services.
- Preventive maintenance program design
- Pump overhaul & reconditioning
- Mechanical seal replacement & upgrade
- Alignment & balancing services
- Spare parts management
04 — Applied Engineering
Applied Engineering
Specialized engineering studies and technical support for complex pumping and fluid handling problems — providing the analysis and recommendations needed for confident engineering decisions.
- Pump system network modeling
- Water hammer & transient analysis
- NPSH available vs. required analysis
- Affinity law calculations & re-rating
- Engineering report preparation
05 — Energy
Energy Optimization
Systematic energy auditing and optimization programs for pumping systems — identifying and eliminating inefficiencies to reduce operating costs and achieve measurable energy savings, typically 15–50%.
- Pump efficiency field testing
- VFD application analysis & justification
- Impeller trimming optimization
- System resistance reduction analysis
- Energy savings measurement & verification
06 — Retrofit
Retrofit & Upgrades
Engineering-designed retrofit and upgrade solutions that extend equipment life, improve performance, and bring aging systems up to current standards — without the cost and downtime of full replacement.
- Performance upgrade redesign
- Material upgrade for corrosive/abrasive service
- Controls & automation modernization
- Hydraulic re-rating to new duty point
- Obsolete equipment replacement strategy
Engineering
Through
the Full Value
Chain
Our services are structured around the complete fluid-energy-control-reliability-operation chain. We identify where value is being lost at each stage and apply targeted engineering solutions to recover it.
1
Fluid — System Analysis
Understanding flow paths, pressure profiles, and fluid properties to define the operating envelope.
2
Energy — Efficiency Optimization
Dentifying where energy is wasted and applying VFD, impeller, or system changes to recover it.
3
Control — Automation Integration
Implementing control strategies that optimize performance, protect equipment, and provide operating visibility.
4
Reliability — Asset Programs
Predictive and preventive maintenance programs that eliminate unplanned downtime before it happens.
5
Operation — Continuous Improvement
Ongoing engineering support to drive continuous performance improvement throughout the asset lifecycle.
Ready to Improve
System Performance?
Describe your challenge and our engineering team will provide a targeted assessment and recommendations — helping you maximize uptime, reduce energy consumption, and extend equipment life.